I used one piece of original sheet metal and added some new...
And now it is welded like it was before...
Plugwelded and there is a seam weld too.
When I removed last of rusted parts, a piece of outer skin showed some rust issue. Had to repair it too...
I had to peel my frame more than I had on my mind. Now it is like peeling an onion... not an orange.
Water and road salt gone in very deep...
Designing new patch...
It was very rough, so new one is about the same. I.e. 3 mm 1/8 "
Done.
Ja sitten kiinni. Laitoin myös tuosta yläreunasta kiinni. Aiemmin vain tuolta alaosastaan pistehitseillä. Tuossa palikassa oli alunperin paikka ja kiinnitysreijät kytkimen nivelen helalle. No niitä ei tällä puolen tarvita...
Welded... Did more welding than original... joined upper and lower part.
Inner fender needed some metal too...
After thet I could weld a new piece of that beam wall.
Welded.
Then outer skin....
Welded...
Finished.
Painted.
Floor needs some sheet metal, but now there is someting to weld on.
This was a six hour job.