The better fender needs some attention too.
One unfinished dent reparation... Finished that one.
![](https://jaatiedostosi.com/juhapih/Eagle3/IMG_1740.jpg)
An unfinished welding job.
![](https://jaatiedostosi.com/juhapih/Eagle3/IMG_1741.jpg)
This bracket had an odd shape, so needed to fix it.
![](https://jaatiedostosi.com/juhapih/Eagle3/IMG_1746.jpg)
My own mistake... made this corner repair 2 cm too short... 3/4 inch.
![](https://jaatiedostosi.com/juhapih/Eagle3/IMG_1747.jpg)
Finished that one.
![](https://jaatiedostosi.com/juhapih/Eagle3/IMG_1749.jpg)
And this...
![](https://jaatiedostosi.com/juhapih/Eagle3/IMG_1751.jpg)
And then that corner, now in right measure.
![](https://jaatiedostosi.com/juhapih/Eagle3/IMG_1750.jpg)
Started to finish rear hatch.
![](https://jaatiedostosi.com/juhapih/Eagle3/IMG_1783.jpg)
Left that locking screw area untouched.
![](https://jaatiedostosi.com/juhapih/Eagle3/IMG_1782.jpg)
Cut that bad rust away.
![](https://jaatiedostosi.com/juhapih/Eagle3/IMG_1784.jpg)
Testing...
![](https://jaatiedostosi.com/juhapih/Eagle3/IMG_1785.jpg)
Start...
![](https://jaatiedostosi.com/juhapih/Eagle3/IMG_1787.jpg)
Done...
![](https://jaatiedostosi.com/juhapih/Eagle3/IMG_1788.jpg)
![](https://jaatiedostosi.com/juhapih/Eagle3/IMG_1790.jpg)
Outside looks fine.
![](https://jaatiedostosi.com/juhapih/Eagle3/IMG_1792.jpg)
There were a couple of odd dents here.
![](https://jaatiedostosi.com/juhapih/Eagle3/IMG_1793.jpg)
Painted this repair area inside of the hatch. Not an easy task... But now it is done.
to be continued....