Project: Medusa

[Will]

HELP!  In desperate need of these clips!

[priya]

If that isn't it perhaps another option is to find one of those rapid prototyping places that can scan one into a computer and "print" the 3 dimensional model in a tub full of powdered plastic.  Probably be pretty pricey but if you gotta have 'em you gotta have 'em.

[shaggimo]

Used to be available at the nest store, but not since its shutdown, try your local Body Shop supply jobber (not advance or auto zone, etc).

[Will]

I need help finding the following:

1) Interior trim.  Both drivers and passenger side.




2) Thought that there was some kind of plastic that went on these things.




3)  Got one.  Need the other! 

[Will]

Got most of the trim back on her last weekend.  Will get the engine and the dual exhaust knocked out over thanksgiving. 

[eagleman]

Now thats sweet! Really like it. If you find the round hood bumpers will you let me know where you found them? I need a couple myself. I did see the trim pieces you are looking for on the big auction site. May not be the color your looking for but you can easily fix that. Again love your car!

[EAGLER]

 :oOH man that eagle really looks amazing. love your car

[jim]

Great looking Eagle.
#2 at one time had a plastic bushing on the post.  The Help aisle has replacement posts that don't require bushings - the post is as large as the old bushing.  I replaced several but don't have the parts number.  Some of the members here will probably have it.  That's how I found them.

[BenM]

On the strikers, people have used copper pipe to replace the plastic since it's soft. It behaves reasonably like the old nylon would. Alternatively, several layers of heat-shrink tubing have been tried as well.

[shaggimo]

Man that looks sharp  .

[MudPuppy]

For the hood bumper
(whole kit or just bumper)

http://www.americanpartsdepot.com/HoodsParts.htm


71-88
All
Hood Bumper Kit - 2 or 3 required (bumper & bolt )
120 0107B
$11.50
   

61-88
All
Front Hood Bumper
120 0105
$4.50



http://www.kennedyamerican.com/buildCatalog.asp

Hood
front hood rubber bumper-on adjuster
DT256
$5.00
   

I can only find the whole strikers (all steel and stainless), neither have any rubber bits it looks like.

   

[eagleman]

Found a great solution for the door striker nylon sleeve. A few months ago I purchased a cheep siphon kit for around ten bucks that worked for a short time before giving up. Guess it didn't like the brand gas I was using. Anyway when I pitched it I kept all the nylon tubing in case I might find a use for it. Well I did! I cut a piece big enough to fit on the striker in the recessed part then slit it and then put it on the striker. It fit perfectly and I shut the door. Now the door sounds great when it closes and it only took a few minutes to do. Sounds so good when the door closes that I am going to do the rest of the doors also. Should last for quite a while being nylon and besides I have a life long supply of this stuff.

[68AMXGOPAC]

On those side trims pieces - do need an exact match or can you paint them to match ok ?
Pm me , more likely to see the reply, I stripped out an SX4 couple years ago, but I think it's a shade lighter in trim color.....not sure

[ISOAR]

Got most of the trim back on her last weekend.  Will get the engine and the dual exhaust knocked out over thanksgiving. 

That thing looks great! Nice color combinations.

[shanebo]

Now that sir is one beautiful SX4....I think your gonna have to change her name to Aphrodite...Beautifully executed restoration. Quick too!