News: Putting FUN and FRIENDLINESS, FIRST into owning and learning about AMC small bodied cars, primarily Eagles, Spirits and Concords as well as vehicles built in AMC's Mexican subsidiary, VAM.

The AMC Eaglepedia can now be accessed using the buttons found below  This is a comprehensive ever growing archive of information, tips, diagrams, manuals, etc. for the AMC Eagle and other small bodied AMC cars. 

Also a button is now available for our Face Book Group page.

Welcome to the AMC Eagles Nest.  A new site under "old" management -- so welcome to your new home for everything related to AMC Eagles, Spirits and Concords along with opportunities to interact with other AMC'ers.  This site will soon be evolving to look different than it has and we will be incorporating new features we hope you will find useful, entertaining and expand your AMC horizons.

You can now promote your topics at your favorite social media site by clicking on the appropriate icon (top upper right of the page) while viewing the topic you wish to promote.


  • November 21, 2024, 11:54:13 AM

Login with username, password and session length

« previous next »
Pages: [1]   Go Down

Author Topic: Oil pan gaske?  (Read 3368 times)

0 Members and 1 Guest are viewing this topic.

Offline shanebo

  • Without "me" its just "aweso"
  • AMC Eagles Den Addicted
  • ********
  • Posts: 2335
  • Thumbs Up 71
  • 80's chicks are the hottest!
Oil pan gaske?
« on: March 09, 2011, 01:40:22 AM »
Im getting the engine tore down on my bird and im at the point of doing the oil pan gasket. I have seen several posts saying the engine must be pulled to replace it...can I just undo the motor mounts and raise in up a bit to get to it or does it have to be all the way out.
Logged
AMC, serving up heaping helpings of AWESOME since 1954

Offline Draekon

  • Eagle Sport
  • ****
  • Posts: 368
  • Thumbs Up 22
Re: Oil pan gaske?
« Reply #1 on: March 09, 2011, 02:18:38 AM »
Here are the steps for the removal of the oil pan given by the 1981 TSM.  They don't have you remove the engine, but it may be just as easy to pull to engine for replacement.  Not sure if partially raising the engine would work.

Quote
(1) Drain engine oil.
(2) Lock steering wheel.
(3) Remove air cleaner.
(4) Support engine with holding fixture as illustrated
in figure 1B-46.
(5) Raise automobile and support at side sills.
(6) Mark for assembly reference and disconnect
front drive shaft.
(7) Remove bolts at engine cushions.
(8) Remove bolts from sill-to-crossmember brace
bar at crossmember, and rotate bar out of way.
(9) Loosen pitman arm at gear.
(10) Loosen idler arm at steering linkage.
(11) Remove bolt from steering damper at
crossmember.
(12) Loosen sway bar bolts and lower sway bar.
(13) Support axle assembly with jack.
(14) Disconnect half shafts from axle. Compress half
shafts inward (toward wheels) and secure in compressed
position with wire attached to frame sills.
(15) Remove bolt from right bracket at axle tube bolt
bars.
(16) Remove bolts from left upper axle bracket at
upper end.
(17) Remove bolts from pinion end bracket at pinion.
(18) Remove vent hose and remove axle assembly.
(19) Support crossmembers with jack.
(20) Remove crossmember nuts and bolts.
(21) Lower .crossmember assembly for pan
clearance.
(22) Remove starter motor.
(23) Remove torque converter inspection shield.
(24) Remove oil pan screws.
(25) Remove oil pan by sliding it rearward.
Logged

Offline shanebo

  • Without "me" its just "aweso"
  • AMC Eagles Den Addicted
  • ********
  • Posts: 2335
  • Thumbs Up 71
  • 80's chicks are the hottest!
Re: Oil pan gaske?
« Reply #2 on: March 09, 2011, 10:09:25 PM »
Sweet! Thanks for that list Draekon!! On the bright side half the work is already done as I have the tranny, the driveshafts, and the intake and exhaust manifolds removed at this point....I'm sure glad I didn't put off the oil pan gasket till after the car was back together....I would have had a good post for the "don't do this" section...LOL

Logged
AMC, serving up heaping helpings of AWESOME since 1954
Pages: [1]   Go Up
« previous next »
 

SMF spam blocked by CleanTalk