So I'm almost ready to put my stroker motor into my eagle but one of the roadblocks I'm going to be hitting is the wiring harness. I have a complete engine compartment wiring harness from a '93 XJ, but because it's from an XJ it has a different bulkhead connector (which also means a different pin out as well). I was wondering if anyone had a diagram for splicing the XJ harness into the eagle harness.
This may help a little...
https://amceaglesden.com/guide/Joshpit%27s_4.0_Swap_Article
That helps a little bit only mine is an OBD1 not an OBD2.