Print Page - replacement vacuum lines

Title: replacement vacuum lines
Post by: Mr_Roboto on August 13, 2022, 01:36:38 AM

I've got a couple of the steel vacuum lines that are clogged. I'm planning on capping stuff up probably until I get something else to deal with it. What's the typical solution here? Just go all plastic? Is there steel still made in the same diameter?

Title: Re: replacement vacuum lines
Post by: MIPS on August 13, 2022, 12:09:41 PM

I'd just take compressed air and blow the line out.

Title: Re: replacement vacuum lines
Post by: maddog on August 15, 2022, 05:23:03 PM

I agree with MIPS unless there's a rotted spot in the line it should come out with compressed air.

Title: Re: replacement vacuum lines
Post by: Mr_Roboto on September 07, 2022, 10:38:02 AM

I have a line or two that won't blow out even with 90 PSI and I have another line that's cut. I think this had water in it/was disconnected for quite some time.

AMC Eagle Den Forum

The Shop => Axle / Differential => Topic started by: Mr_Roboto on August 13, 2022, 01:36:38 AM