Not sure where to put this as it is electrical but on a modified eagle. If in the wrong spot feel free to move it.
I am looking for a bulkhead pinout connector diagram for my 88 eagle. The car had a 4.0 swapped prior to my purchase but remained carburated. I have most of the Hesco stuff to do the swap other than the wiring harness. I have a harness and the computer out of a 94 manual wrangler but may pick up the Hesco harness anyway to make it as easy as possible.
I did pick up the reproduced 84-88 eagle TSM and was surprised to find that the wiring diagrams aren't included in it like the earlier AMC TSMs. Anybody have a bulkhead pinout connector diagram for an 88 eagle to help me move this nice project to the next phase? Looking to continue using it as my regular driver and EFI would be nice in the cold and to improve the fuel economy. Could also use the 94 wrangler 4.0 bulkhead pinout diagram if anyone has it handy.
I have done this update on my Gremlin I can email you the diagrams for the jeep harness I used. As far as the pin out I just used a test light to locate the power and grounds I needed from the bulkhead depending if I needed on power or start power or run.
PM sent!. thanks!