I got a wiring harness for the center gauge cluster, but I can't remember where to connect the fuse panel ends. Can someone with a gauge package post a picture of their fuse panel?
These are the connectors for the fuse panel I can't remember. The black connector goes to the tach.
(https://fbcdn-sphotos-f-a.akamaihd.net/hphotos-ak-ash3/248013_10104416117082854_1768678185_n.jpg)
Here are 2 of the 3 lines in the engine compartment (ground not shown). The bare one went to the coil I believe (black w/tr). The other line with the connector I'm not sure about (black). Would this be the oil pressure sending unit?
If I don't have a coil (put in an HEI), where would the coil wire go now?
(https://sphotos-b.xx.fbcdn.net/hphotos-snc6/408513_10104416155700464_1647743107_n.jpg)
Quote from: macdude443 on May 13, 2013, 08:07:10 PM
If I don't have a coil (put in an HEI), where would the coil wire go now?
On the HEI distributor, there should be two connectors, one for switched battery positive, and the other is for a tach connection.