AMC Eagle Den Forum
The Mighty 258 => The Engine => Topic started by: kral on October 16, 2011, 02:43:04 PM
-
.I went to take out the old bird for a ride thats when I noticed the oil spill, it was a mess. Upon closer inspection it looks like all the oil ran out the very bottom of the oil pan, I dont see any other signs of a leak. I think it might be time for a replacement,a trip to the local yard is in order.My question is, can I pull any oil pan from a Jeep ?
-
No. has to be an eagle pan.
-
yup, oil pan is eagle specific. Some will tell you that it can be changed by lifting the motor off the mounts, but when i tried that I couldn't get the new pan on and ended up having to pull the engine.
-
yup, oil pan is eagle specific. Some will tell you that it can be changed by lifting the motor off the mounts, but when i tried that I couldn't get the new pan on and ended up having to pull the engine.
I did that. It will work. However a lot of work.
-
yup, oil pan is eagle specific. Some will tell you that it can be changed by lifting the motor off the mounts, but when i tried that I couldn't get the new pan on and ended up having to pull the engine.
I did that. It will work. However a lot of work.
we tried and tried we couldn't get that last inch to get the new pan to slide up in. we used a bobcat as an engine hoist and we where actually lifting the car trying for that last inch
-
Make sure where the oil is coming from.
The rear of the valve cover and the rear main seal of the crankshaft are common spots.
-
yup, oil pan is eagle specific. Some will tell you that it can be changed by lifting the motor off the mounts, but when i tried that I couldn't get the new pan on and ended up having to pull the engine.
I did that. It will work. However a lot of work.
we tried and tried we couldn't get that last inch to get the new pan to slide up in. we used a bobcat as an engine hoist and we where actually lifting the car trying for that last inch
I gave the motor an 1"3/4 lift. Than gave myself a liftto the suspensiom. Eventually it wtecked the halfshaft.
-
thanks guys that will save a weekend, I pull the pan & get better idea of WTF went wrong I'll start searching the boards next weekend for a replacement . KRUD, :banghead: