Anyone know where to get the alledged special O ring for putting the speedometer cable back in ?? It says everywhere to be sure to replace it with a new one, and my parts guy doesn't have a listing for it. I figured the dip stick would just be a regular O ring ??Or are they both "special" ? Thanks
I just used the o ring that was on the speedometer ..... that trans should have the speedo cut off check both of them and use the better looking of the 2 ...... as far as dipstick o ring I am currently on the hunt for one myself after we get the valve cover and HEI installed
I have a universal viton o ring kit which is an assortment of sizes. Anyway no idea of which one fit that dipstick but I just matched it up
Its a "crush" O ring, supposedly to only be used once. I would think any MoPar parts source could get them.
Thanks everyone , currently what is in there ( the replacement Tcase) , is just about a tube and half of silicone,lol. I'll check the local Chrysler place.NAPA and another local parts place had no clue.I have an assortment of regular O rings for the dipstick, just checking with the Forum.
I Just re-used my old ring and added a bead of Blue RTV sealant around the outside edge. When I go back in this spring to adjust the speedo cable (Speedometer is showing about 12 kmh slower that actual speed) I will just put another bead of Blue RTV on it again, then fill the t-case. My T case is an NP119 so it uses 10W30 oil. I am not sure how the RTV would hold up to ATF, though.
Cheers
HI Went to Harbor Freight and got an assortment of o rings . there has to be 100 or so in it . it has paid for its self...........Don
i would go to a transmission shop like aamco and see if you can get one there.
I had put one in, and it leaked. Then I used The Right Stuff by Permtex. Works on everything from Fuel pumps, sending units, thermostat housings too!