Choose style:

Author Topic: Head Gasket  (Read 54 times)

0 Members and 1 Guest are viewing this topic.

Offline pfay82

  • Hatchling
  • *
  • Posts: 1
  • Thumbs Up 0
Head Gasket
« on: April 08, 2018, 08:18:15 PM »
Hi everyone! I'm replacing my head gasket and am having trouble putting the head back on the block. I just can't get the gasket to stay put, and am having a horrible time getting everything lined up enough to drop the head bolts back in. Even if something is off by a fraction of a millimeter, it won't work. Any suggestions? :banghead:

Online mudkicker715

  • Administrator
  • AMC Eagles Den Addicted
  • ******
  • Posts: 2366
  • Thumbs Up 160
Re: Head Gasket
« Reply #1 on: April 08, 2018, 09:01:33 PM »
I can say i never had such a problem. It should be straight forward.



Manitowoc WI

Offline mo.eagles

  • Eagle DL
  • ***
  • Posts: 194
  • Thumbs Up 10
Re: Head Gasket
« Reply #2 on: April 13, 2018, 05:13:34 PM »
If you are replacing your head bolts you can cut the head off two of the old ones , hacksaw a slot in the top for a screw driver and screw them into the block (finger tight) ,drop your gasket on then set the head down ( using the bolts as guides) . Use a screw driver to get the bolts back out. After you started a couple head bolts in to hold it in place.
'85 wagon Limited   tilt wheel , cruise control
power seats ,windows and locks
rear window washer /wiper 
tach and gauge package
A/C
 '85 wagon   power windows and locks
rear window washer/wiper
factory tow package
A/C
 '84 wagon parts

 

Page created in 0.033 seconds with 21 queries.