Choose style:

Author Topic: 'Big Cap' ignition upgrade (the saga continues): grounding question  (Read 643 times)

0 Members and 1 Guest are viewing this topic.

Offline johnbendik

  • Eagle
  • **
  • Posts: 126
  • Thumbs Up 12
I am troubleshooting some new problems after doing an ignition upgrade (big cap and rotor, 8 mm wires, new plugs at .045 gap, Pertronix 3 ohm coil, resistor bypass, and new BWD CBE7P ignition module from Advance Auto).  The problems are some stutters and dropouts when accelerating.

I need a better understanding of the grounding problems that some posters have warned about.  They mention a grounding wire from the distributor harness to the fender that is sometimes not functional.  Where does this wire attach to the fender? 'Cause I can't find it.  (Which, of course, may be the problem)

I can see the flat ribbon strap grounding the engine to the frame, and there's a grounding point on the passenger side firewall where several auxiliary relays connect to.  But I don't see anything grounding to the fender except my newly installed headlight relays.

Thanks to all,
JB
1984 Eagle Sportwagon
258 - 6 cyl
5-speed !

Offline IowaEagle

  • AMC Eagle Archivist
  • Administrator
  • AMC Eagles Den Addicted
  • *****
  • Posts: 31978
  • Thumbs Up 471
Re: 'Big Cap' ignition upgrade (the saga continues): grounding question
« Reply #1 on: January 17, 2015, 10:03:30 PM »
Check the schematics in the AMC Eaglepedia to make sure.  But I think its grounded at the ICM.
Click for Toledo, IA Forecast" border="0" height="100" width="150   


Not a Jeep.  Not a Car.  Its an AMC Eagle!

1982 Eagle SX/4 Sport;
1980 Concord DL;
1970 Ambassador 2 Dr HT, SST
2002 Hyundai Santa Fe;
2008 Jeep Patriot Sport - Freedom Drive II

Offline macdude443

  • Eagle Sport
  • ****
  • Posts: 463
  • Thumbs Up 24
Re: 'Big Cap' ignition upgrade (the saga continues): grounding question
« Reply #2 on: September 22, 2015, 02:42:09 PM »
Just noticed this.  I know it's old.  Just to clarify, the black wire in the 3-wire ICM<->Distributor pickup harness is the ground.  The Dist/ICM grounds through the distributor base/block.  It is recommended by some to tap into that black wire and create a dedicated ground, as the dist base gets dirty and becomes an unreliable ground point.  If I remember right, the ICM enclosure is not grounded.
1982 Eagle SX/4
1986 Eagle Wagon

 

Page created in 0.045 seconds with 22 queries.