The Shop > Axle / Differential
replacement vacuum lines
(1/1)
Mr_Roboto:
I've got a couple of the steel vacuum lines that are clogged. I'm planning on capping stuff up probably until I get something else to deal with it. What's the typical solution here? Just go all plastic? Is there steel still made in the same diameter?
MIPS:
I'd just take compressed air and blow the line out.
maddog:
I agree with MIPS unless there's a rotted spot in the line it should come out with compressed air.
Mr_Roboto:
I have a line or two that won't blow out even with 90 PSI and I have another line that's cut. I think this had water in it/was disconnected for quite some time.
Navigation
[0] Message Index
Go to full version