AMC Eagle Den Forum
The Shop => Axle / Differential => Topic started by: Mr_Roboto on August 13, 2022, 01:36:38 AM
-
I've got a couple of the steel vacuum lines that are clogged. I'm planning on capping stuff up probably until I get something else to deal with it. What's the typical solution here? Just go all plastic? Is there steel still made in the same diameter?
-
I'd just take compressed air and blow the line out.
-
I agree with MIPS unless there's a rotted spot in the line it should come out with compressed air.
-
I have a line or two that won't blow out even with 90 PSI and I have another line that's cut. I think this had water in it/was disconnected for quite some time.