Choose style:

Author Topic: Concord rear sway bar  (Read 919 times)

0 Members and 1 Guest are viewing this topic.

Offline DaemonForce

  • Grease Magnet
  • Eagle Limited
  • *****
  • Posts: 525
  • Thumbs Up 8
Concord rear sway bar
« on: August 08, 2014, 10:55:54 PM »
I recently picked a rear sway bar and various linkage pieces from an 83 Concord and I'm wondering if there's a way to make this work with the back end of an 83 Eagle. I see some obvious points in the Dana 35 Concord and Eagle. The U bolts on the Eagle are an actual U shape while the Concord's were flipped. My Eagle's differential sits under the leaf springs while the Concord's rear rests above the leafs. Did I miss something important?
1983 Limited
AMC 258C {R2:27.Jun.13}
Carter 2681 {R2:28.Oct.12}
TorqueFlite A998 {R6: -20.Apr.12}
NP129 {R2:28.Apr.12}
M35-273 {???}
Compression: 0
Corrected Idle: 0RPM

Rebuild:
???

Offline carnuck

  • Having a 727 means never re-doing the trans again
  • AMC Eagles Den Addicted
  • ********
  • Posts: 3449
  • Thumbs Up 89
  • Near Seattle
    • Virtual Jeep
Re: Concord rear sway bar
« Reply #1 on: August 10, 2014, 01:27:12 AM »
I did it with just the rear frame brackets remounted and longer end links on my previous wagon with almost 8" of rear lift. (I was midway through the front lift when I found major frame rot and scrapped it)
AMC/Jeep gauges are for amusement only. Any correlation between them and reality is purely coincidental!

 

Page created in 0.026 seconds with 21 queries.