Choose style:

Author Topic: Walker Part #'s  (Read 14885 times)

0 Members and 1 Guest are viewing this topic.

Offline IowaEagle

  • AMC Eagle Archivist
  • Administrator
  • AMC Eagles Den Addicted
  • ******
  • Posts: 31978
  • Thumbs Up 471
Re: Walker Part #'s
« Reply #15 on: July 19, 2008, 08:26:14 AM »
Are you talking about the pipe that crosses back over behind the transfer case?  If so, I used the series 50 pipe which they did have.  BUT, it fit because I substituted the cat converter with a straight piece of pipe and was able, then, to make the crossover work.  I am guessing, that if you still have your cat converter the series 50 one can be cut to fit the series 50 cars.
Click for Toledo, IA Forecast" border="0" height="100" width="150   


Not a Jeep.  Not a Car.  Its an AMC Eagle!

1982 Eagle SX/4 Sport;
1980 Concord DL;
1970 Ambassador 2 Dr HT, SST
2002 Hyundai Santa Fe;
2008 Jeep Patriot Sport - Freedom Drive II

Offline vangremlin

  • Administrator
  • AMC Eagles Den Addicted
  • ******
  • Posts: 3634
  • Thumbs Up 181
Re: Walker Part #'s
« Reply #16 on: July 19, 2008, 10:26:46 AM »
I need to replace everything back of the exhaust manifold as they cut the exhaust pipe in front of the cat converter when it was in the junkyard.  And I need to have the cat because I have to pass the emissions test and have the original setup here in the Denver area.  So I need the pipe that goes between the cat and the muffler.  And it sounds like the pipe from the bigger eagles will work, with a little trimming?  How much work is it - I am a total novice at exhaust systems and have not special equipment like a welder, bender, etc.  Thanks.
1981 Kammback 258 - "Pepe"
1980 Coupe 258 - "Ginger
1972 Gremlin X 304
1978 Gremlin 4 cyl 121 - sold
1964 TBird 390 - sold

Offline IowaEagle

  • AMC Eagle Archivist
  • Administrator
  • AMC Eagles Den Addicted
  • ******
  • Posts: 31978
  • Thumbs Up 471
Re: Walker Part #'s
« Reply #17 on: July 19, 2008, 10:49:12 AM »
Everything is pretty much a direct fit.  If you go with one of the aftermarket cats which slide over the header pipe you will probably have no problem with that intermediate pipe since you will probably have some adjustment room.  You will have to match the Cat ends to make sure they fit the pipes you are installing.  So, I would think you would want a cat that slides over the header pipe, so you will need to get the outside dimension of the header pipe and then get a cat with that end as the inside dimension.  So, I would first order the rest of the exhaust, that way you can see what the dimensions are of the intermediate pipe.  Then fit trial it all in, except for the Cat, and then see what dimensions Cat will work for you.  Get the proper universal Cat and then put it all together.  Leave everything kind of loose behind the Cat so you can get everything where you want it.  Work front to back, is what I do.
Click for Toledo, IA Forecast" border="0" height="100" width="150   


Not a Jeep.  Not a Car.  Its an AMC Eagle!

1982 Eagle SX/4 Sport;
1980 Concord DL;
1970 Ambassador 2 Dr HT, SST
2002 Hyundai Santa Fe;
2008 Jeep Patriot Sport - Freedom Drive II

Offline vangremlin

  • Administrator
  • AMC Eagles Den Addicted
  • ******
  • Posts: 3634
  • Thumbs Up 181
Re: Walker Part #'s
« Reply #18 on: July 19, 2008, 11:53:39 AM »
Thanks.  Will give it a shot!
1981 Kammback 258 - "Pepe"
1980 Coupe 258 - "Ginger
1972 Gremlin X 304
1978 Gremlin 4 cyl 121 - sold
1964 TBird 390 - sold

Offline jim

  • AMC Eagles Den Addicted
  • ********
  • Posts: 6484
  • Thumbs Up 102
Re: Walker Part #'s
« Reply #19 on: April 26, 2010, 09:28:30 PM »
I had no luck at Advance finding Maremont or 157691.
A search for mufflers brought up a bunch but not enough info about them for me.
They seem to have been dropping our parts lately; I wonder if this is another example?
I'm right 98% of the time, and I don't care about the other 3%.
"The constitutions of most of our States assert that all power is inherent in the people;
that... it is their right and duty to be at all times armed."
--Thomas Jefferson to John Cartwright, 1824. ME 16:45
What part of "shall not be infringed" do they not understand?
08 Impala
01 Yukon 4X4
(There's more to life than fuel mileage)
83 Eagle wagon; shared responsibility as daily driver
88 Eagle white woody wagon; shared responsibility as daily driver
86 wagon parts car
Click for Little Rock, AR Forecast" border="0" height="100" width="150

Offline jim

  • AMC Eagles Den Addicted
  • ********
  • Posts: 6484
  • Thumbs Up 102
Re: Walker Part #'s
« Reply #20 on: April 26, 2010, 09:47:07 PM »
I was just on rockauto.  They have a bunch of stuff listed but that part of the site is extremely user unfriendly.
I was not able to tell what I was looking at.
I may call them.
I certainly wasn't happy with O'Reilly, Advance and NAPA online.
I haven't looked at Walker yet.
I'm right 98% of the time, and I don't care about the other 3%.
"The constitutions of most of our States assert that all power is inherent in the people;
that... it is their right and duty to be at all times armed."
--Thomas Jefferson to John Cartwright, 1824. ME 16:45
What part of "shall not be infringed" do they not understand?
08 Impala
01 Yukon 4X4
(There's more to life than fuel mileage)
83 Eagle wagon; shared responsibility as daily driver
88 Eagle white woody wagon; shared responsibility as daily driver
86 wagon parts car
Click for Little Rock, AR Forecast" border="0" height="100" width="150

Offline eagleone

  • Eagle Limited
  • *****
  • Posts: 583
  • Thumbs Up 73
Re: Walker Part #'s
« Reply #21 on: April 26, 2010, 10:05:34 PM »
I tried to get an intermediate pipe for my SX/4 but the Walker site said it was not available. No one around here lists one. Fortunately there is a muffler shop near here that can probably bend one for me.
1981 SX/4 (Baby Bugly))
1986 Eagle Wagon (Bugly)
"The system you are using is perfect for the results you are getting."

Offline joey

  • LUV THY EAGLE
  • Eagle
  • **
  • Posts: 106
  • Thumbs Up 10
Re: Walker Part #'s
« Reply #22 on: April 28, 2010, 10:34:31 PM »
I've yet to put my new exhuast on because I  had a prob with my cat ordered it from checkers. They gave me a universal one which I did not want because it didn't have the plate to mount it to the very first piece of pipe off of the manifold. But I had no problems getting the intermediate pipe you guys are talking about from rockauto. Universal cats are short and stubby with about three inches of pipe to attach the rest of the exhuast to. Direct fit cats have an extra like 8 inches with a mounting plate attached on the front with the back having three inches to attach to the intermdiate pipe.
       

Offline greymarooneightytwo

  • Eagle DL
  • ***
  • Posts: 160
  • Thumbs Up 9
Re: Walker Part #'s
« Reply #23 on: January 11, 2013, 12:30:36 AM »
That old link is dead, as dead as this thread.

This image is from their site. Looks like 82-88 excluding Kammback and SX4

« Last Edit: January 11, 2013, 12:32:16 AM by greymarooneightytwo »

Offline vangremlin

  • Administrator
  • AMC Eagles Den Addicted
  • ******
  • Posts: 3634
  • Thumbs Up 181
Re: Walker Part #'s
« Reply #24 on: January 12, 2013, 12:05:54 AM »
If I remember correctly, its the intermediate pipe (part #42634) which is different on the small Eagles.
1981 Kammback 258 - "Pepe"
1980 Coupe 258 - "Ginger
1972 Gremlin X 304
1978 Gremlin 4 cyl 121 - sold
1964 TBird 390 - sold

Offline SpreadEagle

  • Eagle Sport
  • ****
  • Posts: 362
  • Thumbs Up 12
Re: Walker Part #'s
« Reply #25 on: January 12, 2013, 10:07:24 AM »
I don't need a cat on mine and the muffler shop here by be says $175 from manifold back. No inspection here but for the money I hear on this thread I can have in installed. Wonder if the shop can bend another set for needy members.
'81 Kammback
'81 SX/4(Parts)

Offline vangremlin

  • Administrator
  • AMC Eagles Den Addicted
  • ******
  • Posts: 3634
  • Thumbs Up 181
Re: Walker Part #'s
« Reply #26 on: January 12, 2013, 10:13:29 AM »
That's a good price!
1981 Kammback 258 - "Pepe"
1980 Coupe 258 - "Ginger
1972 Gremlin X 304
1978 Gremlin 4 cyl 121 - sold
1964 TBird 390 - sold

 

Page created in 0.056 seconds with 22 queries.